Amp Clamp Press Release

FOR IMMEDIATE RELEASE

NEW PRODUCT RELEASE!

A609 Adaptor!

Read below for more info.

Rig Innovations

CONTACT:

Lee Houk (509) 994-1548 www.HoukMarketing.com

DATE: October, 2007

The AMP-CLAMP is a unique product that has existed for six years. This is a product that has been in great demand by working musicians for years and its convenience is a godsend for stage technicians and working musicians, vastly reducing set-up time. The Amp-Clamp comes standard in anodized black, and can be custom ordered in any color (requires at least a 2 week lead time for special order colors). Optional base plates, shorter tubes and accessory mounting side extension (A609) is available at a extra cost. Made in the USA

	Effortlessly find your speaker's optimal dynamic "sweet spot" every time, consistent placement
	Stationary placement allows your speaker cabinet to be moved without loss of critical microphone placement
	Low profile, will attach to any speaker cabinet (even amps without a lip) from small combos to 4x12 cabinets
	Eliminates stage clutter, never trip over your microphone stand on stage again
	Eliminates raised floor feed back & "foot-steps" from hollow stages
	Eliminates Mic-Stand "hum"
	Setup and tear down in seconds, light-weight, portable and easy to carry, Fits in any GiG Bag or Case

New 609 Mic Accessory

This new accessory is available for the amp clamp.

Its for mics like the Sennheiser flat mount model, or AKG condenser type mics

(if you don't want to use the Shock suspension mount) that mounts at different angles than a typical SM57 type.

New Prototype finish below (similar to shot peened)

This may look white, but it is aluminum after the special process.

We will also probably be offering the tube part in shorter only lengths as an accessory

along with spare mounting base plates.

DB Bryant, new signed Blues Rock Artist

    " I finally got a couple of pictures for you. We shot them at a club after the show Sunday night.
The Amp Clamp definitely kicks ass! I've never used or seen anything that comes close

as far as easily placing the mics in the sweet spots on my Marshall cabinet.

It's simple and efficient design is a breeze to install and the mic stays where you put it.

There'll be no more last minute adjustments after a tired sound tech slaps a stand somewhere near my amp right before a show!

I'll definitely be spreading the word on this innovative tool for the working musician. Thumbs all the way UP for the Amp Clamp!

                                                                                  Thanks for everything,

                                                                                             db